I need an estimate on wiring and installing a box for a ciling fan.

Thomas L

Hi, our outlets are not grounded. I would like an estimate for getting them grounded properly. Thanks a lot,

Julian F

We want to install a ceiling fan/light in a room that currently has no overhead light or switch. Nor sure if there is wiring in the ceiling or if a line will have to be run. Room is on the 1st floor, so there is a room above the ceiling in question. It is also a popcorn ceiling. Looking for the best electrician in Kansas City.

Layla B

Power went out yeterdayfor our entire area. Power came back on this morning. However, only some of the outlets are currently working. I have reset all of the breakers multiple times. No change. I have some outlet power, but no lights. Very strange. I am not sure if the breaker box was damaged at the time of the power outage. We have had no problems with it in the past. It is old, the push type breakers. I need to get the power working again to all parts of the house.

Brian F

I have a GFCI circuit which is "slow-tripping" the GFCI receptacle. This is the garage and outside circuit. I also have two plugs in the masterbath which are not working, which I would like to have functional. Call if you have additional questions. Thanks.

Bill M

Master bathroom fan/light inoperative. Resetting circuit breakers has no effect. Main bathroom outlet intermittent. Also interested in a separate estimate for wiring a circuit breaker panel input for a standby portable generator. Wish to run water pump, refrigerator, and potentially Nat Gas furnace fan in case of power outage at the flip of a few switches.

Brian H

I am planning on finishing my basement. I need some additional lighting and some plugs moved to fit the new floor plan

Charles W

The following items showed up on my inspection report and I am needing to have them worked out before closing on the sale of my home can happen. 1) "The main service entrance panel box is not labeled for AMP capacity. The panel should be further inspected and rated by a professional electrician. 2)"hard wired smoke detectors are required to be labeled in the panel and wired to a dedicated circuit breaker." 3) "aluminum service wiring requires anti-oxidizing agent at entry points to the main breaker and neutral bar in the main panel" 4)"the main service entrance exhibits neutral wires have been double lugged at the Nuetral bar. This installation can cause an overheating condition between the two or more wires. Each neutral wire should be seperated and assigned its own lug for connection" 5) "individual circuit breakers in the main panel are not labeled for their specific use or apparatus controlled."

Emily C

I want to install more lighting in my backyard

Cora R

We had an inspection done on a house and he recommended a electrician look at the panel box. these were his comments. The panel box is located in the master bedroom closet. Panel box is manufactured by Zinsco and utilizes a stab lock breaker; these breakers have been known to have failed in over loaded conditions. We wanted to get an estimate on how much it would cost to have it looked at and an estimate on how much it would cost if it needed to be updated and moved to the outside of the house.

Scott F